Sunday, June 25, 2006

Tmnet Streamyx WRT54G and DSL600eu configuration

I was having some problem to get both of them working together. I screwed up the settings and tried my very best to get it working. Finally i manage to get the internet up and running. I thought it would be good to post it up on how i solve it for my future reference(just in case if i need it) or for some of you who might need it. Here's a step by step in getting those hardware to cooperate..

Free Image Hosting at www.ImageShack.us
Step 1. Open Internet Explorer. In the Address Bar, type in http://192.168.1.1 and hit enter. If the page successfully loads, you will be met with the screen shown in the image on the right. If the page does not load or you receive an error indicating "Cannot find server" or "The page cannot be displayed", click here; you may need to remove a static IP address on your network interface card (NIC). If the page loads correctly, enter a Username and Password of admin and admin respectively and click Log In.

Free Image Hosting at www.ImageShack.us
Step 2. After logging in, you will be met with the Quick Start page. We need to click on the Setup button at the top of the page, then click on Connection 0 from the left side of the page.

Free Image Hosting at www.ImageShack.us
Step 3. After clicking on Connection 0, you will see the PPPoE Connection Setup page. In the upper right corner, change the Type from PPPoE to Bridge. This will cause the screen to change, see the next step.

Free Image Hosting at www.ImageShack.us
Step 4. Now that the page has changed, type in 8 for the VPI and 35 for the VCI. Then click Apply.

Free Image Hosting at www.ImageShack.us
Step 5. When you click Apply, a small pop-up will come up stating that the Browser will try connecting the gateway in a few seconds. This message is unimportant in our situation. Simply click OK to bypass the message.

Free Image Hosting at www.ImageShack.us
Step 6. After bypassing the previous message, you will receive a warning about DHCP. Simply click it off and proceed to the next step.

Free Image Hosting at www.ImageShack.us
Step 7. Now that you have bypassed both pop-up messages, click on DHCP Configuration under LAN Setup. Once the page loads, select Server and Relay Off and click Apply. Once your settings have applied, click on Save Settings from the menu on the left side of the page.

Step 8. Once you receive a message stating that your settings have been successfully saved, click the Reboot link from the menu on the left side of the page. After the reboot has finished, wait 2 minutes then check the DSL light on the modem. Is it steady? If so, you have successfully configured your modem for Bridged Mode.

Your Ad Here